I set up my VPN server using local bridge + dnsmasq according to this website:
https://blog.lincoln.hk/blog/2013/05/17 ... al-bridge/
I can connect to my VPN server and getting IP from dnsmasq but can't access to the internet, although I can access to the internet using a built-in softether securenat feature
I found this topic on the internet but I don't think my VPS is Nat VPS like op of this topic
topic link : https://www.lowendtalk.com/discussion/9 ... net-access
thanks for reading
Softether using local bridge + dnsmasq
-
- Posts: 6
- Joined: Sat May 01, 2021 5:10 am
Re: Softether using local bridge + dnsmasq
ok guys I think this is because of the nat problem how can I know if my VPS behind a nat ? and how can I find the internal IP address of it not my public one
-
- Posts: 1
- Joined: Wed Aug 04, 2021 2:54 pm
Re: Softether using local bridge + dnsmasq
Hello,
The easiest way is to look at your VPS physical NIC. If the ip address stated in there some private ip address, it means your VPS uses NAT.
Thank you.
The easiest way is to look at your VPS physical NIC. If the ip address stated in there some private ip address, it means your VPS uses NAT.
Thank you.
-
- Posts: 6
- Joined: Sat May 01, 2021 5:10 am
Re: Softether using local bridge + dnsmasq
thanks i found this and i dont thing its related to private ips so there is no nat ?
ens192: <BROADCAST,MULTICAST,PROMISC,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UP group default qlen 1000
link/ether 00:50:56:b0:93:0c brd ff:ff:ff:ff:ff:ff
inet 136.243.xxx.xxx/24 brd 136.243.xxx.xxx scope global ens192
valid_lft forever preferred_lft forever
inet6 fe80::250:xxx:xxx0:xxxc/64 scope link
valid_lft forever preferred_lft forever
ens192: <BROADCAST,MULTICAST,PROMISC,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UP group default qlen 1000
link/ether 00:50:56:b0:93:0c brd ff:ff:ff:ff:ff:ff
inet 136.243.xxx.xxx/24 brd 136.243.xxx.xxx scope global ens192
valid_lft forever preferred_lft forever
inet6 fe80::250:xxx:xxx0:xxxc/64 scope link
valid_lft forever preferred_lft forever
-
- Posts: 11
- Joined: Mon Oct 04, 2021 6:37 pm
Re: Softether using local bridge + dnsmasq
hi
if the VM itself is not in NAT means that you cannot do it without VirtualNat enabled
i would recommend you to look here
if the VM itself is not in NAT means that you cannot do it without VirtualNat enabled
i would recommend you to look here
Code: Select all
https://whattheserver.com/softether-vpnserver-with-port-forwarding/