the network connection was aborted by the local system.

seccentral · Post by **seccentral** » Mon May 05, 2014 2:42 pm

I have 2 servers, one cluster controller one cluster member.
On the controller I leave defaults, edit the virtual hub add a user test with pass test.

Then I try connecting via SSTP on a win8.1 64bit client. (importing the self signed cert etc)
everything leads to "the network connection was aborted by the local system."

If I remove clustering i can connect to any of the two servers perfectly.

Why does this happen ?
controller config http://pastebin.com/BnZZCUUe
member config http://pastebin.com/FFzEYr1E

seccentral · Post by **seccentral** » Fri May 09, 2014 2:06 pm

Post by **thisjun** » Tue May 20, 2014 2:12 am

In cluster mode, you can use only SoftEther protocol.

seccentral · Post by **seccentral** » Tue May 20, 2014 8:15 am

thank you for the reply

theodisbutler · Post by **theodisbutler** » Tue May 27, 2014 1:47 am

I wish this was clear upfront.

seccentral · Post by **seccentral** » Thu May 29, 2014 10:56 am

so did i

the network connection was aborted by the local system.

the network connection was aborted by the local system.

Re: the network connection was aborted by the local system.

Re: the network connection was aborted by the local system.

Re: the network connection was aborted by the local system.

Re: the network connection was aborted by the local system.

Re: the network connection was aborted by the local system.