Routing problem or...

Post your questions about SoftEther VPN software here. Please answer questions if you can afford.
Post Reply
zyzy
Posts: 1
Joined: Mon Feb 18, 2019 9:22 pm

Routing problem or...

Post by zyzy » Fri Feb 22, 2019 10:01 pm

Hi,
I have installed SE server on CENTOS on vmware (two nics: public a.b.c.8 and local 192.168.128.150)
Configured by SEwindowsAdministrator. Run, works fine (whatmyip address shows a.b.c.8 on client)
But there is a problem. Client cant see local network (192.168.128.0)
Local network is vlan 30 (there are vmware ESxi 192.168.128.170, Dell MD3220 - 192.168.128.101 and APC ups in remote location (other building) - 192.168.128.130)
Ping from vpn client works only to 192.168.128.130. I can ping from client to 192.168.128.170, 192.168.128.101 only few seconds after restart vpn server, after it stops.
Ping from 192.168.128.150 (vpn server nic2) works to all IP in 192.168.128.0/24

Where is the problem? (I have tested fresh installations on fedora, ubuntu - the same result; ping only to 192.168.128.130)


Regards

thisjun
Posts: 2458
Joined: Mon Feb 24, 2014 11:03 am

Re: Routing problem or...

Post by thisjun » Tue May 21, 2019 4:51 am

Could you explain more about configuration?
Use localbridge? Use SecureNAT? How to assign an IP address? etc.

Post Reply