Is this a port enabling problem? A5V11 ramips/mipsel
Posted: Thu Sep 27, 2018 8:37 am
I compiled and installed SE on the small beast, photo is attached. I used extroot 200MB SWAP and 500MB rootfs. Small USB stick is visible on the photo.
I use OpenWrt ChaosCalmer 15.05.1. Eth0 static address 10.52.254.44, I used it to connect OpenWrt LUCI in browser, also for ssh terminal.
I already tried two separate routers, one server, one bridge. No success to get Online status in bridge.
So I made following test: ( I believe this test can be very usefull for other people as well! )
I was not sure that compiled binaries are OK, but this test proves (?) they should be OK.
- I installed on signle router vpnserver, vpnbridge and vpncmd. all not started automatically!
- I started vpnserver manually
- started vpncmd, check pased, password setup
- using windows manager I set up everything in server, saved DNS symbolic address
- manually stopped vpnserver, widows manager disconnected from server
- then I started manually vpnbridge
- started vpncmd, check pased, password setup
- using windows manager I set up everything in bridge, provided DNS symbolic address of vpnserver
- I left windows manager connected to the bridge, checking its status
as server was not running it could not connect and go Online
- then over ssh terminal I manually started vpnserver, so both server and bridge are running
wuala! bridge gets connected Online! see attached screenshot.
somewhere on internet I found how to set up ports enabling for OpenWrt, so I made it, see attached screenshot
I think it was for server only and I am not sure if it is also sufficient for bridge, or if it is even correct at all?
With this setting if in single router (server and bridge) it gets connected, but in two separate devices no.
Any idea where is the problem??
I use OpenWrt ChaosCalmer 15.05.1. Eth0 static address 10.52.254.44, I used it to connect OpenWrt LUCI in browser, also for ssh terminal.
I already tried two separate routers, one server, one bridge. No success to get Online status in bridge.
So I made following test: ( I believe this test can be very usefull for other people as well! )
I was not sure that compiled binaries are OK, but this test proves (?) they should be OK.
- I installed on signle router vpnserver, vpnbridge and vpncmd. all not started automatically!
- I started vpnserver manually
- started vpncmd, check pased, password setup
- using windows manager I set up everything in server, saved DNS symbolic address
- manually stopped vpnserver, widows manager disconnected from server
- then I started manually vpnbridge
- started vpncmd, check pased, password setup
- using windows manager I set up everything in bridge, provided DNS symbolic address of vpnserver
- I left windows manager connected to the bridge, checking its status
as server was not running it could not connect and go Online
- then over ssh terminal I manually started vpnserver, so both server and bridge are running
wuala! bridge gets connected Online! see attached screenshot.
somewhere on internet I found how to set up ports enabling for OpenWrt, so I made it, see attached screenshot
I think it was for server only and I am not sure if it is also sufficient for bridge, or if it is even correct at all?
With this setting if in single router (server and bridge) it gets connected, but in two separate devices no.
Any idea where is the problem??