bridge softether vpnpool to lan

Post your questions about SoftEther VPN software here. Please answer questions if you can afford.
Post Reply
Posts: 3
Joined: Fri Sep 09, 2016 8:27 pm

bridge softether vpnpool to lan

Post by red » Thu Feb 01, 2018 11:58 pm

I have a test config just about working with current Softether on CentOS 6.3.

1. I have a subnet of vpnpool users assigned to from the local bridge to the OS's tap adapter. the OS's dhcp is successfully providing ip addresses to vpn users when connected. I can ping the ip address of the tap_vpn from vpn connected users and ping back the user's pool address from the vpnserver shell.

2. I have eth0 and 1 available in the LAN's subnet and can ping anywhere on the lan from the OS shell running the softether.

What I cannot figure out the best way to do is to bridge/route traffic between the tap_vpn and eth0/1. I am not sure if I can do this from the softether management gui or if I need to do this in the linux host OS. I would like to be able to filter traffic once the bridging is done.

Help with this probably basic step would be appreciated.

Posts: 2454
Joined: Mon Feb 24, 2014 11:03 am

Re: bridge softether vpnpool to lan

Post by thisjun » Thu Feb 15, 2018 6:20 am

What network address is used on eth0/1?
Is it same to VPN network address?

Post Reply