I have just set up routing one lan to lan site with Layer 3 Swith with partial success. Some someone can assist me please!
Here is my config.
Network 1 (Server):
Bridged local LAN with this Hub1.
Network 2 (Bridge Client):
Connects tu Server to Hub2.
Bridged local LAN with this Hub2
Layer 3 Switch.
I can see on each IP tables the ips of respective internal network plus the IP of the Layer 3 Switch.
From both, the server (192.168.1.135) and the bridge client (10.10.10.60) I can ping the virtual interface of the Layer 3 Switch 192.168.1.254 and also 10.10.10.254, but I can't ping any other PC from any side...
I have no added any route to the layer 3, but I added routes via command line (Windows CMD) to:
route add 10.10.10.0 mask 255.255.255.0 192.168.1.254
route add 10.10.10.255 mask 255.255.255.255 192.168.1.254
route add 192.168.1.0 mask 255.255.255.0 10.10.10.254
route add 192.168.1.255 mask 255.255.255.255 10.10.10.254
If I add to any other PC from eather site the route of the opposite site, the same happens, I can ping both virtual interfaces layer 3 switch IPs, but not any internal.
Do I have to turn on any other setting on Windows or softethernet server or bridge client?
On openVPN I know I would have to turn on the Windows Service "Routing and Remote Access", but I tried that also with no success.
I only have open port 5555 of the server, and the bridge and cascade connection seems is established.
I followed carefully this guide https://www.softether.org/4-docs/1-manu ... P_Routing) with no success.
Please let me know if this is the correct Forum.
Post your questions about SoftEther VPN software here. Please answer questions if you can afford.
1 post • Page 1 of 1