Setting a private adress on a bridge

Mada · Post by **Mada** » Thu Oct 08, 2015 7:01 pm

Is it possible to set a private ip address on a bridge server running windows?

Post by **thisjun** » Thu Oct 22, 2015 6:40 am

Mada · Post by **Mada** » Tue Nov 17, 2015 7:54 pm

thisjun wrote:
> Yes.

Ok, where? In the windows adapter settings / Network Connections?

Manual says remove windows ipv4 stack. In this case I would need it there?

Thanks

raafat · Post by **raafat** » Tue Nov 17, 2015 10:28 pm

Why do you need it ?

Mada · Post by **Mada** » Wed Nov 18, 2015 7:22 pm

Well, to get access to the bridge-computer.
It is behind ISP-NAT so I can not call it from internet side. And on the local lan, it has no ip.

So I want an ip address to call that will go through the bridge itself.

Post by **thisjun** » Thu Nov 26, 2015 6:28 am

>> In the windows adapter settings / Network Connections?
Yes.

If you want to remove IPv4 stack, you need another adapter.

Setting a private adress on a bridge

Setting a private adress on a bridge

Re: Setting a private adress on a bridge

Re: Setting a private adress on a bridge

Re: Setting a private adress on a bridge

Re: Setting a private adress on a bridge

Re: Setting a private adress on a bridge