Routing between networks (Mikrotik)

Post your questions about SoftEther VPN software here. Please answer questions if you can afford.
Post Reply
Posts: 1
Joined: Wed May 30, 2018 8:53 am

Routing between networks (Mikrotik)

Post by TristanS » Wed May 30, 2018 9:06 am

After many days desperately trying to get this setup working I'd be grateful for any advice.

The basic setup is as follows:
- 3 Sites (RB750)
- MS Win Server 2012 running Softether
- 3 virtual hubs (so that there is just one client on every hub to get the same IP every time)
- L3 switch activated
- Routes to local networks set up (e.g. via

Routing between all clients is possible (to the router as vpn-client), but still impossible to reach the respective network behind the router.
(See sketch below)

Basic setup:


I would be very grateful for any suggestions!

Posts: 2817
Joined: Mon Feb 24, 2014 11:03 am

Re: Routing between networks (Mikrotik)

Post by thisjun » Thu Jun 14, 2018 7:23 am

What VPN protocol do these routers use?

Why there are three virtual hubs?

Post Reply